G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
6. Raise up the door glass and hold with a suction lifter.
7. Remove the power window motor mounting bolts, and remove the regulator from the panel.
8. Disconnect the connector for the regulator assembly.
Installation
Install in the reverse order of removal.
Inspection after removal
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
-
Gear wear
-
Regulator deformation
-
Spring damage
-
Grease condition for each sliding part
The arrows in the figure show the application points of the grease "Dow Corning Moly Coat SK623" or equivalent.
SETTING OF LIMIT SWITCH
When any of the following work has been done, reset the limit switch (integrated in the motor).
-
Removal and installation of the regulator.
-
Removal and installation of the motor from the regulator.
-
Operate the regulators as a unit.
-
Removal and installation of the glass.
-
Removal and installation of the glass run.
Resetting