G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
4. Using a flat-bladed screwdriver as shown in the figure, remove retaining ring from torque member.
5. Place a wooden block as shown in the figure, and blow air from union bolt mounting hole to remove piston and piston boots.
6. Remove piston seal with a flat-bladed screw driver.
CAUTION: Be careful not damage cylinder inner wall.
INSPECTION AFTER DISASSEMBLY
Cylinder Body
CAUTION: Use new brake fluid to clean. Never use mineral oils such as gasoline or kerosene.
^
Check the inner wall of cylinder for corrosion, wear, and damage. If a failure is detected, replace cylinder body.
^
Minor flaws caused by corrosion or foreign material can be removed by polishing the surface with a fine sandpaper. Replace cylinder body, if
malfunction is detected.
Torque Member
Check for wear, cracks, and damage. If a malfunction is detected, replace applicable part.
Piston
CAUTION: The piston sliding surface is plated. Do not polish with sandpaper.
Check the piston surface for corrosion, wear, and damage. If a malfunction is detected, replace applicable part.
Sliding Pin Bolt and Sliding Pin Boot
Check sliding pin bolts and sliding pin boot for wear, damage, and cracks. If a malfunction is detected, replace applicable part.
ASSEMBLY
CAUTION: When assembling, do not use NISSAN rubber Grease (KRE00 00010, KRE00 00010 01).
1. Apply rubber grease to new piston seals, and install them to groove on cylinder body.