G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
/Page-1485002.png)
1. Clamp flange of cylinder body in vise as shown in the figure.
CAUTION:
^
Using copper plate or cloth to cover flange for securing vise.
^
When securing master cylinder assembly in a vise, be sure not to over tighten.
^
Be sure to fix the flange part with the installation side of cylinder body brake tube up.
2. Using a pin-punch [commercial service tool: diameter approximately 4 mm (0.16 inch)], remove pin form reservoir tank.
3. Remove master cylinder assembly from vise.
4. Remove reservoir tank and grommet from cylinder body.
ASSEMBLY (FOR 2WD MODEL)
CAUTION:
^
Do not use mineral oils such as kerosene, gasoline during the cleaning and assembly process.
^
Do not drop parts. If a part is dropped, do not use it.
1. Apply brake fluid to a grommet, and place it into master cylinder to install.
CAUTION: Do not reuse grommet.
2. Install reservoir tank to master cylinder.
CAUTION:
^
Do not reuse reservoir tank and reservoir tank mounting pin.
^
Pay attention to the orientation of reservoir tank.
