G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
/Page-553002.png)
2. Remove camshaft position sensor (PHASE) (right and left banks) from cylinder head back side.
CAUTION:
^
Handle carefully to avoid dropping and shocks.
^
Do not disassemble.
^
Do not allow metal powder to adhere to magnetic part at sensor tip.
^
Do not place sensors in a location where they are exposed to magnetism.
3. Remove intake valve timing control solenoid valves.
^
Discard intake valve timing control solenoid valve gaskets and use new gaskets for installation.
4. Remove intake and exhaust camshaft brackets.
^
Mark camshafts, camshaft brackets, and bolts so they are placed in the same position and direction for installation.
^
Equally loosen camshaft bracket bolts in several steps in reverse order shown in the figure.
5. Remove camshaft.
6. Remove valve lifter.
^
Identify installation positions, and store them without mixing them up.
