G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
6. Use scraper to remove all traces of liquid gasket from cylinder head and camshaft bracket (No. 1).
INSTALLATION
1. Apply liquid gasket of 3.0 mm (0.12 inch) diameter to position shown in the figure [both edges of camshaft bracket (No. 1)] (on both banks). Use
Genuine RTV Silicone Sealant or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS".
^
First, apply it to engine longitudinal direction [5.0 mm (0.197 inch) + 5.0 mm (0.197 inch) side in figure].
2. Install rocker cover.
^
Check if rocker cover gasket is not dropped from installation groove of rocker cover.
3. Tighten bolts in two steps separately in numerical order as shown in the figure.
1st step
Tightening Torque: 0.96 - 2.96 Nm (0.10 - 0.30 kg-m, 9 - 26 inch lbs.)
2nd step
Tightening Torque: 7.33 - 9.33 Nm (0.75 - 0.95 kg-m, 65 - 82 inch lbs.)
4. Install PCV hose.
^
Insert PCV hose by 25 to 30 mm (0.98 to 1.18 inch) from connector end.
^
When installing, be careful not to twist or come in contact with other parts.
^
Install PCV hose between right and left rocker covers with its identification paint facing upward (right rocker cover side). Refer to component
figure in "Removal and Installation".
5. Install in the reverse order of removal after this step.