G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
/Page-617005.png)
22. Remove O-rings from rear timing chain case.
23. Remove water pump cover and chain tensioner cover from front timing chain case.
^
Use seal cutter [SST: KV10111100 (J-37228)] or equivalent tool to cut liquid gasket for removal.
24. Remove front oil seal from front timing chain case using suitable tool.
^
Use flat-bladed screwdriver for removal.
CAUTION: Be careful not to damage front timing chain case.
25. Remove timing chain tensioner (primary) as follows:
a. Pull lever down and release plunger stopper tab.
^
Plunger stopper tab can be pushed up to release (coaxial structure with lever).
b. Insert stopper pin into tensioner body hole to hold lever, and keep tab released.
NOTE: Allen wrench [2.5 mm (0.098 inch)] is used for a stopper pin as an example.
c. Insert plunger into tensioner body by pressing slack guide.
d. Keep slack guide pressed and hold it by pushing stopper pin through the lever hole and body hole.
e. Remove mounting bolts and remove timing chain tensioner (primary).
