infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC's P1031/P1051/P1148/P1168|Page 8572 > < Engine Controls - ECM Reprogramming Information|Page 8567
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC's P1031/P1051/P1148/P1168

Classification:
EC04-022a

Reference:
ITB04-027a

Date:
August 28, 2006

2004-2005 FX35 AND G35; MIL "ON" WITH DTC P1031, P1051, P1148, P1168

ITB04-027 has been amended and supersedes ITB04-023 Please discard all previous versions of these bulletins.

APPLIED VEHICLES:
2004-2005 FX35 (S50) and G35 (V35)

APPLIED VINS:
G35 Sedan 2WD After JNKCV51E(*)4M6000001
G35 Sedan 4WD After JNKCV51F(*)4M7000001
G35 Coupe After JNKCV54E(*)4M8000001
FX35 2WD After JNRAS08U(*)4X105001
FX35 4WD After JNRAS08W(*)4X210001

Vehicles built After October 2003.

APPLIED DATES:

IF YOU CONFIRM:

A MIL "ON" with the following DTC(s) stored:

On 2004 MY vehicles ONLY

^

P1031 / P1051 (A/F Sensor Heater), and/or

^

P1148 / P1168 (A/F Sensor Closed Loop Control),

On 2005 MY vehicles ONLY

^

P1148 / P1168 (A/F Sensor Closed Loop Control),

ACTIONS:

Step A: Use Consult II to confirm this bulletin applies:

^

Check the Current ECM Part Number.

^

Perform A/F Sensor test to confirm proper air fuel operation.

If the A/F sensor fails the test this bulletin does not apply. Go back to ASIST for further repair information.

^

Compare your Current ECM Part Number to Chart A.

If that part number does not match one in Chart A, this bulletin does not apply. Go back to ASIST for further diagnostic and repair information.

Step B: If this bulletin applies, reprogram the ECM.

IMPORTANT:

The purpose of "ACTIONS" (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service
Procedure as it contains information that is essential to successfully completing this repair.

CLAIMS INFORMATION

Engine Controls - MIL ON/DTC's P1031/P1051/P1148/P1168|Page 8572 > < Engine Controls - ECM Reprogramming Information|Page 8567