G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
CAUTION:
DO NOT perform this step if the procedure is being done on the vehicle (Method # 1). Doing so may cause metal debris to enter the engine
cylinders.
14. If metal debris remains trapped in the boss threads use a spiral nylon brush to remove it.
15. Tilt the manifold/catalyst/front tube so that the metal debris falls out of the part.
16. Apply compressed air through the boss to blow out any remaining debris.
CAUTION:
DO NOT perform this step if the procedure is being done on the vehicle (Method # 1 ). Doing so may cause metal debris to enter the engine
cylinders.
17. Install the new sensor as described in the applicable Electronic Service Manual (ESM).
Disclaimer