G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
6. Clip / snap the BTS connector onto the new bracket (see Figure 5d).
NOTE:
The bracket is loose (not mounted) at this point in the procedure.
7. Install a tie-wrap (P/N 24216 - S5800) around the connector as shown in Figure 5d.
a. Route the tie-wrap through the holes in the bracket.
b. Position the tie-wrap so the excess end is not straight down.
c. Pull the tie-wrap tight.
d. Cut the excess tie-wrap flush so there is no sharp edge.
8. Install a "mounting clip type" tie-wrap (P/N 24225 - 79900) as shown in Figure 5d.