G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
4. Remove rotor snap ring with snap ring pliers, and remove shaft kit from body assembly.
CAUTION: When removing rotor snap ring, be careful not to damage pulley shaft of shaft kit.
5. Using a screw driver, remove oil seal for body assembly.
6. Remove cam ring, rotor, vane, side plate, O-ring B and O-ring C from body assembly.
7. Remove plug, then remove O-ring D, flow control valve spring, relief valve assembly and flow control valve assembly from body assembly.
CAUTION: Be careful not to drop and deform relief valve assembly and flow control valve assembly.
8. Remove fixing bolt of suction connector assembly, then remove suction connector assembly and O-ring E from body assembly.
ASSEMBLY
NOTE: Fix oil pump in vise as occasion demands.
CAUTION: When retaining drive shaft in a vise. always use copper or aluminum orates between vise and shaft.
1. Apply a coat of Multi-purpose grease or equivalent to oil seal lip and to the circumference of oil seal. Using proper tool such as hand press
machine, install it to the body assembly.
NOTE: Do not reuse oil seal.
2. Install shaft kit to body assembly.
3. Apply a coat of NISSAN PSF or equivalent to O-ring B and O-ring C, then install O-ring B and O-ring C to body assembly.
NOTE: Do not reuse O-ring B and O-ring C.