G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
Parking Brake Shoe: Testing and Inspection
Inspection and Adjustment
Inspection and Adjustment
INSPECTION AFTER REMOVAL
Lining Thickness Inspection
^
Check thickness (A) of lining.
Drum Inner Diameter Inspection
^
Check inner diameter (B) of drum.
Other Inspections
^
Check the lining for excessive wear, damage, and peeling. Replace if necessary.
^
Check the brake shoe sliding surface for excessive wear and damage. Replace if necessary.
^
Check the anti-rattle pin and retainer for excessive wear, damage and rust. Replace if necessary.
^
Check the adjuster spring, return spring and anti-rattle spring for settling, excessive wear, damage, and rust. Replace if necessary.
^
Check the adjuster for smoothness. Replace if necessary.
^
Check the toggle lever for excessive wear, damage and rust. Replace if necessary.
^
Visually check inside of the drum for excessive wear, cracks, and damage with a pair of vernier calipers. Replace if necessary.
ADJUSTMENT AFTER INSTALLATION
^
Adjust the parking brake pedal stroke or lever stroke.
^
Perform break-in operation as follows after replacing brake shoe and/or disc rotor, or if brakes do not function well.
1. Adjust parking brake pedal stroke or lever stroke to the specified amount.
2. Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
Drive forward
^
Vehicle speed: Approx. 30 km/h (19 MPH) set (constant and forward)
^
Parking brake operating force: Approx. 294 N (30 kg, 66 lb) set constant
^
time: Approx. 35 sec.
CAUTION: To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
3. After the break-in procedure, check parking brake pedal stroke or lever stroke of parking brake. If it is out of the specification, adjust again. Refer
to PB-3, "PEDAL TYPE: Inspection and Adjustment" (pedal type), PB-4, "LEVER TYPE: Inspection and Adjustment" (lever type).
See: Parking Brake Pedal/Testing and Inspection
See: Parking Brake Lever/Testing and Inspection