G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
1.
Remove the rear door partition glass run and place on a clean surface.
^
Refer to section GW in the Service Manual for removal information.
NOTE:
The partition glass and partition glass run will be removed together.
2.
Apply foam tape onto the upper curved part of the partition glass run as follows:
a.
Use a clean shop cloth and isopropyl alcohol to wipe away all dirt and debris off of the curved part of the partition glass run.
b.
Cut a 150 mm (6 inch) length by 4 mm (3/16 inch) wide by 4 mm (3/16 inch) thick piece from the foam tape strip (listed in the Parts
Information section of this bulletin).