G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
1: Quick connector
<=: Vehicle front
Disconnect quick connector as follows:
-
Hold the sides of connector, push in tabs and pull out fuel feed tube.
-
If quick connector sticks to tube of main fuel level sensor unit, push and pull quick connector several times until they start to move. Then
disconnect them by pulling.
A: Pull
B: Push in tabs
CAUTION:
-
Quick connector (1) can be disconnected when the tabs (F) are completely depressed. Do not twist it more than necessary.
B: Connection (Cross-section)
D: To under floor fuel line
E: To fuel tank
G: Disconnection
-
Do not use any tools to disconnected quick connector.
-
Keep resin tube (C) away from heat. Be especially careful when welding near the resin tube.
-
Prevent acid liquid such as battery electrolyte, etc. from getting on resin tube.
-
Do not bend or twist resin tube during installation and disconnection.
-
Do not remove the remaining retainer (2) on hard tube (or the equivalent) (A) except when resin tube or retainer is replaced.
-
When resin tube or hard tube (or the equivalent) is replaced, also replace retainer with new one.
Retainer color: Green