G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
/Page-866001.png)
Technical Service Bulletin # 00-005D
Date: 070512
Engine Controls - ECM Reprogramming Information
Classification:
EC99-014d
Reference:
ITB00-005d
Date:
May 12, 2006
ECM REPROGRAMMING FOR INFINITI VEHICLES
This amended version (ITB00-005d) updates the Service Procedure section of the bulletin. Please discard all previously released copies of ITB00-005.
APPLIED VEHICLE(S):
1999 Q45(FY33)
All 2000 and later
SERVICE INFORMATION
^
In-vehicle ECM reprogramming is available to update the ECM on 1999 Q45 and all 2000 and later vehicles.
^
This reprogramming allows the vehicle ECM to be upgraded to the latest operating specifications without removal or replacement of the ECM.
^
When an ECM has been reprogrammed it will display a new P/N on the CONSULT-II screen.
NOTE:
ECM reprogramming will not effect NATS.
^
ECM reprogramming requires the use of ASIST 8.0 or higher and CONSULT-II with the ECU Reprogramming Software Card (orange color).
^
Use the Service Procedure steps to transfer ECM reprogramming data from the ASIST PC to CONSULT-II and from CONSULT-II to the vehicle
ECM.
^
Refer to the ECU Reprogramming Software Operations Manual (in ASIST) for additional information on using CONSULT-II for ECM
reprogramming.
CAUTION
^
An ECM should be reprogrammed ONLY when required by a specific Infiniti Technical Bulletin or as otherwise directed by Nissan North
America.
^
The ECM can be permanently damaged if the reprogramming procedure is not followed exactly.
^
Do not disturb (don't touch) the vehicle CONSULT-II or the DLC-II cable while ECM reprogramming is in progress.
^
If the ECM is damaged, it must be replaced.
Disclaimer
Service Procedure
NOTE:
When ECM reprogramming is required to repair a vehicle a Technical Service Bulletin will be issued.
ECM reprogramming involves two general steps:
^
Download (transfer) data from ASIST into CONSULT-II.
^
Download new data from CONSULT-II into the vehicle (Reprogram ECM).
