infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Engine Controls - CONSULT-III(R) ECM Programming|Page 3999 > < Engine Controls - CONSULT-III(R) ECM Programming|Page 3997
Page 3
background image

The GR-8 (Battery and Electrical Diagnostic Station) set to "Power Supply" mode is recommended.

CAUTION

For Hybrid Vehicles

^ Use the GR-8  Battery and Electrical Diagnostic Station.

^ If needed, refer to Hybrid Service TSBs for connecting the GR-8 to the Hybrid 12V battery.

CAUTION

4. Turn the ignition ON with the engine OFF.

^ The engine must be OFF (not running) during the reprogramming procedure. For Hybrid vehicles, Make sure the dash warning lights are ON and the

"READY" light is OFF.

^ Turn OFF all vehicle electrical loads such as exterior lights, interior lights, HVAC, blower, rear defogger, audio, NAVI, seat heater, steering wheel

heater, etc.

CAUTION

5. Make sure the engine cooling fan(s) are not running.

If the cooling fans are running:

a. Turn the ignition OFF.

b. Wait for the engine to cool.

c. Turn the ignition ON (with engine OFF).

Engine Controls - CONSULT-III(R) ECM Programming|Page 3999 > < Engine Controls - CONSULT-III(R) ECM Programming|Page 3997