G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
^
If the cable is disconnected before "Complete" is displayed you MUST restart the transfer (download) procedure; otherwise ECM damage
can occur.
^
If the cable is disconnected during the transfer; wait for ASIST to display an "error message then click on "OK". Select "Backup" then
return to step 6.
11.
When transfer is complete (see Figure 9):
A.
Select (click on) "Okay" then "MAIN MENU".
B.
Turn OFF CONSULT-II.
C.
Disconnect the AC power cord and the Ethernet cable from CONSULT-II.
DOWNLOAD NEW DATA FROM CONSULT-II INTO THE VEHICLE (REPROGRAM ECM)
CAUTION:
Perform this operation in four (4) sections. DO NOT SKIP any of these sections. They must be performed in order 1 through 4.
^
Section 1: Connect a battery charger and CONSULT-II to the vehicle.
^
Section 2: Confirm the vehicle battery voltage and CONSULT-II "Charger Input".
^
Section 3: Perform ECM Reprogramming.
^
Section 4: Perform ECM Reprogram Confirmation.
Section 1: Connect a battery charger and CONSULT-II to the vehicle.
12.
Confirm the ignition switch is "OFF".
13.
Connect a battery charger to the vehicle battery.
A.
Set the charger at a low charge rate (trickle charge).
IMPORTANT
Do not perform ECU reprogramming without connecting a battery charger to the vehicle's battery. Permanent ECU damage can occur.
Connecting a vehicle battery charger will maintain:
^
Proper CONSULT-II power supply during reprogramming-very important if the CONSULT-II battery is low.
^
Vehicle battery voltage level-especially on late model vehicles where the cooling fans come on during reprogramming.