G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
14.
Connect CONSULT-II to the vehicle using the DLC-II cable with black Converter Box (see Figure 10).
VERY IMPORTANT:
^
Make sure the DLC-II is straight and fully plugged in to the vehicle.
^
Make sure all other DLC-II cable connections shown in Figure 10 are connected properly.
CAUTION
^
Infiniti requires the use of essential tools shown in Figure 10 when performing ECM reprogramming.
^
J44200-10 "Pigtail" should not be removed from the CONSULT-II DDL Port. This Pigtail allows use of the stronger "quick disconnect"
cable set.
^
If cables are very often changed at the DDL Port (base) of the CONSULT-II, unit cable connector pin damage may result.
^
If there is connector pin damage ECM reprogramming may fail. Permanent ECU damage can occur.
15.
Turn "ON" the ignition switch (do not start the engine).
^
CONSULT-II will turn ON automatically (see Figure 11).
^
Confirm that all electrical loads* (except for the ignition) are "OFF".
^
* Headlights defroster A/C Audio (radio) and cellular telephone etc.