G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
4. Disconnect air bag module harness connector.
NOTE:
-
For installing/removing driver air bag module connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
-
Install connector with lock raised, and push lock into connector.
-
After installing the connector, check that the lock is pushed securely into it.
5. Remove the driver air bag module.
CAUTION:
-
Always place air bag module with pad side facing upward.
<=:Vehicle upper
-
Do not insert any foreign objects (screwdriver, etc.) into air bag module.
-
Do not disassemble air bag module.
-
Do not use old TORX bolts after removal; replace with new bolts.
-
Do not expose the air bag module to temperatures exceeding 90 °C (194 °F).
-
Do not allow oil, grease or water to come in contact with the air bag module.
-
Replace the air bag module if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION: