G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
Accelerator Pedal Position Sensor: Service and Repair
ON-VEHICLE REPAIR
ACCELERATOR CONTROL SYSTEM
Exploded View ACC-3
Exploded View
Removal and Installation
REMOVAL
1. Remove the cap and the inside mounting bolt.
2. Remove accelerator pedal assembly.
3. Disconnect accelerator pedal position sensor harness connector.
CAUTION:
-
Do not disassemble accelerator lever. Do not remove accelerator pedal position sensor from accelerator lever.
-
Avoid impact from dropping etc. during handling.
-
Be careful to keep accelerator lever away from water.
INSTALLATION
Installation is the reverse order of removal.
Inspection
INSPECTION AFTER INSTALLATION
-
Make sure accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.
-
Make sure accelerator pedal securely returns to the fully released position.
-
For the electrical inspection of accelerator pedal position sensor, refer to EC-425, "Description", See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P Code Charts/P2122 EC-429, "Description"
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/P Code Charts/P2127 and EC-434, "Description". See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P Code Charts/P2138
CAUTION: When harness connector of accelerator pedal position sensor is disconnected, perform "Accelerator Pedal Released Position
Learning". Refer to EC-17, "ACCELERATOR PEDAL RELEASED POSITION LEARNING : Description". See: Powertrain