G35x Sedan AWD V6-3.5L (VQ35HR) (2007)
13. Heat rack Teflon ring to approximately 40°C (104°F) with a dryer, and remove rack Teflon ring and O-ring from rack assembly.
CAUTION: Never damage rack assembly. Rack assembly must be replaced if damaged because it may cause fluid leakage.
14. Push rack oil seal inside with a 29 mm (1.14 in) socket and an extension bar to push out rack oil seal (inner side) from gear housing assembly
CAUTION: Never damage gear housing assembly and cylinder inner wall. Gear housing assembly must be replaced if damaged because
it may cause fluid leakage.
ASSEMBLY
1. Apply recommended fluid to O-ring Put an O-ring into a rack Teflon ring.
2. Heat rack Teflon ring to approximately 40°C (104°F) with a dryer. Assemble it to mounting groove of rack assembly.
3. Install the Teflon ring correcting tool [SST: KV48104400 ( - )] from tooth side of rack to fit rack Teflon ring on rack. Compress the ring with tool.