G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
1 : Crankshaft pulley
A : Paint mark
Use the hexagonal part as a guide.
-
By referring to the figure, measure the valve clearances at locations marked "×" as shown in the table below (locations indicated in the figure).
-
No. 3 cylinder at compression TDC
c. Rotate crankshaft 240 degrees clockwise (when viewed from engine front) to align No. 5 cylinder at TDC of compression stroke.
NOTE:
Mark a position 240 degrees (b) from a corner of the hexagonal part of crankshaft pulley mounting bolt as shown in the figure.