G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
/Page-1795012.png)
-
Ruler 30 cm (11.8 in) long
-
Drawing pen
-
Heat gun
-
Alcohol
-
Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of drawing pen.
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver composition on break with drawing pen. Slightly overlap existing heat wire on
both sides [preferably 5 mm (0.20 in)] of the break.
4. After repair has been completed, check repaired wire for continuity. This check should be conducted 10 minutes after silver composition is
deposited.
Do not touch repaired area while test is being conducted.
