G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
Memory Positioning Module: Service and Repair
Automatic Drive Positioner Control Unit
Removal and Replacement
AUTOMATIC DRIVE POSITIONER CONTROL UNIT
Removal and Installation
REMOVAL
CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1. Remove the battery negative terminal.
2. Remove the instrument driver lower panel. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Installation/A/T Models, "A/T
MODELS : Removal and Installation".
3. Remove the screws (A).
4. Remove automatic drive positioner control unit (1).
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be sure to clump the harness to the right place.
NOTE:
After installing the driver seat, perform additional service when removing battery negative terminal. Refer to See: Testing and
Inspection/Programming and Relearning/Additional Service When Replacing Control Unit/Special Repair Requirement.
Exploded View
AUTOMATIC DRIVE POSITIONER CONTROL UNIT
Exploded View
Refer to .