G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
Navigation Module: All Technical Service Bulletins
Navigation Radio - Configuration After Replacement
Classification:
EL10-009a
Reference:
ITB0-017a
Date:
December 1, 2010
AV CONTROL UNIT REPLACEMENT REQUIRES CONSULT-III CONFIGURATION
This bulletin has been amended. Several items have been revised. Please discard previous versions.
APPLIED VEHICLES:
2010-2011 EX35 (J50)
2010-2011 FX35/FX50 (S51)
2010-2011 G37 Coupe Convertible Sedan (C/H/V36)
2011 M37/M56 (Y51)
2011 QX56 (Z62)
SERVICE INFORMATION
If the AV Control Unit needs to be replaced on an Applied Vehicle for any reason follow the steps in the Service Procedure to configure the Multi AV
system.
NOTE:
The original AV Control Unit must be installed in the vehicle while performing part of this procedure. DO NOT remove the original AV Control
Unit until instructed.
SERVICE PROCEDURE
Before starting make sure your ASIST has been freshly synchronized and all CONSULT-III upgrades have been installed.
Parts of the Procedure
1. Make sure the shift selector is in Park.
2. Connect the C-III VI to the vehicle.
3. Turn ON the ignition.
NOTE:
You may want to start the engine to keep the battery charged during this procedure.
4. Open/start ASIST on the C-III computer then select CONSULT Utilities > CONSULT III.
5. Perform the usual C-III start-up selections:
a. Wait for the Detecting VI/MI in progress message to clear.