G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
a. Apply engine oil to O-ring or contact surface of O-ring.
b. Align matching marks (B) of VVEL control shaft position sensor and upper housing.
C : Bank 2
-
Face connector toward matching mark (A).
c. Temporarily tighten bolt.
d. Adjust VVEL control shaft position sensor after setting the engine assembly in the vehicle. Refer to See: Powertrain Management/Computers
and Control Systems/Testing and Inspection/Programming and Relearning/VVEL Control Shaft Position Sensor Adjustment/Description.
CAUTION:
Be sure to adjust VVEL control shaft position sensor.
e. After adjusting VVEL control shaft position sensor, tighten bolts to the specified torque.
12. Inspect the valve clearance. Refer to See: Cylinder Head Assembly/Valve Clearance/Service and Repair.
13. Install in the reverse order of removal after this step.