G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
Blower Motor: Service and Repair
Removal and Installation
Blower Motor
BLOWER UNIT
BLOWER MOTOR : Removal and Installation
REMOVAL
1. Remove instrument lower cover. Refer to .
2. Disconnect blower motor connector (A).
3. Remove mounting screws (B), and then remove blower motor assembly (1).
INSTALLATION
Installation is basically the reverse order of removal.
Blower Unit
BLOWER UNIT
BLOWER UNIT : Removal and Installation
REMOVAL
1. Remove instrument lower panel RH. Refer to .
2. Disconnect ECM (1) connectors.
3. Disconnect AWD control unit (2) connector (AWD models).
4. Remove mounting nuts (A), and then remove ECM with bracket attached.
5. Remove power steering control unit (WITHOUT 4WAS). Refer to See: Relays and Modules/Relays and Modules - Steering and
Suspension/Relays and Modules - Steering/Steering Control Module/Service and Repair/Power Steering Control Unit/Exploded View.
6. Disconnect intake door motor (3) connector and blower motor
(4) connector.
7. Remove mounting bolt (B) and screw (C), from blower unit (5).
8. Remove blower unit.
CAUTION:
Move blower unit rightward, and remove locating pin (1 part) and joint. Then remove blower unit downward.
INSTALLATION
Installation is basically the reverse order of removal.