G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
3. If this bulletin applies and you have performed ECM reprogramming the screen in Figure 2 appears when reprogramming is complete.
NOTE:
If the screen in Figure 2 does not display (reprogramming does not complete).
2009-2010 G37 AT vehicles: Proceed to TCM Reprogramming.
All 2008 G37 vehicles, 2009-2010 G37 MT vehicles: Perform steps 4 and 5 below. DO NOT perform TCM Reprogramming procedure.
4. Make sure to erase DTCs from all systems.
NOTE:
During reprogramming DTCs will set in several systems and must be erased.
5. Test drive the vehicle and make sure it operates correctly and the MIL is OFF.
^ If the MIL comes ON, go back to ASIST for further diagnostic information.
TCM Reprogramming (For 2009-2010 G37 AT vehicles ONLY)
^ Make sure to erase DTCs from all Systems.
^ If you are not familiar with the TCM reprogramming procedure. Refer to "CONSULT- III (C-III) TCM Reprogramming" general procedure.