G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
Power Mirror Switch: Testing and Inspection
Changeover Switch
Component Function Check
DOOR MIRROR REMOTE CONTROL SWITCH
CHANGEOVER SWITCH : Component Function Check
1.CHECK CHANGEOVER SWITCH FUNCTION
Check the operation on "MIR CHNG SW-R" or "MIR CHNG SW-L" in "DATA MONITOR" mode using CONSULT-III.
Is the inspection result normal?
YES - Changeover switch function is OK.
NO - Refer to See: Accessories and Optional Equipment/Memory Positioning Systems/Testing and Inspection/Component Tests and General
Diagnostics/Door Mirror Remote Control Switch/Changeover Switch/Diagnosis Procedure.
Diagnosis Procedure
DOOR MIRROR REMOTE CONTROL SWITCH
CHANGEOVER SWITCH : Description
Changeover switch is integrated into door mirror remote control switch.
Changeover switch has three positions (L, N and R).
It changes operating door mirror motor by transmitting control signal to automatic drive positioner control unit.
DOOR MIRROR REMOTE CONTROL SWITCH
CHANGEOVER SWITCH : Diagnosis Procedure
1.CHECK CHANGEOVER SWITCH INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch connector.
3. Turn ignition switch ON.
4. Check voltage between door mirror remote control switch harness connector and ground.
Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK CHANGEOVER SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit harness connector and door mirror remote control switch harness connector.