G37x Sedan AWD V6-3.7L (VQ37VHR) (2010)
Front Door Window Glass: Service and Repair
Removal and Installation
FRONT DOOR GLASS
Removal and Installation
REMOVAL
1. Remove the front door finisher. Refer to See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Removal and Installation.
2. Remove the door inside seal.
3. Disconnect the front door speaker harness connector and remove the door speaker.
4. Reconnect the front power window control unit LH and the power window main switch finisher.
5. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.
6. Remove the glass mounting bolts, shown by the arrows in the figure.
7. While holding the door glass, raise it at the rear end to pull the glass out of the sash toward the inside of the door.
8. Remove the door glass run.
INSTALLATION
Install in the reverse order of removal.