I35 V6-3.5L (VQ35DE) (2003)
/Page-781010.png)
CAUTION:
DO NOT DISCONNECT THE ETHERNET CABLE UNTIL "COMPLETE" IS DISPLAYED AS SHOWN IN FIGURE 14. If the cable is
disconnected before "Complete" is displayed you MUST restart the download procedure. Otherwise ECM damage can occur.
If the cable is disconnected during the transfer; close ASIST, push "Control/Alt/Delete" and select End task. Then return to step 5.
11.
When transfer is complete select the "Main Menu" button on ASIST. Turn off CONSULT-II and disconnect the AC power cord and the Ethernet
cable from CONSULT-II.
Install ECM Reprogramming data into the vehicle ECM from CONSULT-II
CAUTION:
Perform this operation in three segments. DO NOT SKIP any of these segments.
^
Confirm the vehicle and CONSULT-II battery voltage (blue card).
^
ECM Reprogramming (orange card).
^
ECM Reprogram Confirmation.
Confirm the vehicle and CONSULT-II battery voltage.
12.
Confirm the vehicle's ignition switch is "OFF".
13.
Firmly connect the CONSULT-II cable to the vehicle.
14.
Remove the ECM Reprogramming card from slot A of CONSULT-II and install the Diagnostics (blue) card into slot A (see Figure 15).
CAUTION:
Do not use slot B.
