I35 V6-3.5L (VQ35DE) (2003)
C.
Click "ENTER". The "IP Configuration" window will display the IP Address and Subnet Mask (see Figure 4).
D.
On CONSULT-II touch "SUB MODE", then touch "CONFIGURE ETHERNET".
E.
Compare the IP Address on the ASIST PC with the Address on the Configure Ethernet screen of CONSULT-II.
^
If the first three sets of numbers of the CONSULT-II Address match the IP Address on the ASIST PC (as noted in step 4C above) proceed with step
41 below.
^
If the first three sets of numbers of the CONSULT-II Address do not match the IP Address on the ASIST PC, proceed with step 4F below.
F.
Touch the Address number on the CONSULT-II screen (titled "Configure Ethernet"). A numeric keypad will appear (see Figure 5).
NOTE:
The IP Address for the ASIST PC you are working on will be different from the Address shown in Figure 5.
G.
Use the key pad to set the CONSULT-II Address to match the ASIST PC IP Address with the exception that the CONSULT-II Address
number ends with 176.
H.
Touch "SAVE" and then press "COPY" to print the Address for future reference.
I.
Turn off CONSULT-II to allow the new Address to be saved in memory.
J.
On the ASIST PC close the "IP Configuration" window, close the "MS-DOS Prompt" window, then proceed with step 5.