J30 V6-2960cc 3.0L DOHC (VG30DE) (1995)
Throttle Position Sensor: Adjustments
If throttle position sensor is replaced or removed, it is necessary to install it in the proper position, by following the procedure as shown below:
1. Install throttle position sensor body in throttle body. Do not tighten bolts.
2. Connect throttle position sensor and closed throttle position switch harness connector.
3. Start engine and warm it up sufficiently.
4. Perform "THRTL POS SEN ADJ" in "WORK SUPPORT" mode. Measure output voltage of throttle position sensor using voltmeter.
5. Adjust by rotating throttle position sensor body so that output voltage is 0.4 to 0.5V.
6. Tighten mounting bolts.
7. Disconnect throttle position sensor harness connector for a few seconds and then reconnect it.