M30 V6-181 3.0L (1990)
Inhibitor Switch: Service and Repair
Neutral Safety (Inhibitor) Switch
Fig. 3 Adjusting Inhibitor Switch.
1.
Remove manual control linkage from manual shaft.
2.
Set manual shaft in N position.
3.
Loosen inhibitor switch fixing bolts.
4.
Insert suitable pin (4 mm 0.16 in) into adjustment holes in both inhibitor switch and manual shaft as near vertical as possible, then tighten screws,
Fig. 3.
5.
Check switch for continuity, replacing as necessary.