M35x AWD V6-3.5L (VQ35DE) (2007)
Front Door Panel: Service and Repair
DOOR FINISHER
Removal and Installation
REMOVAL
FRONT AND REAR DOOR FINISHER
1. Fully open door window.
2. Remove inside handle escutcheon and remove screw.
3. Remove arm rest finisher.
4. Remove screw of armrest finisher portion.
5. Insert a thin screwdriver from the armrest finisher opening and lift the lock of the power window switch harness connector.
6. Insert a clip clamp remover into clips on back door finisher, and disengage clips.
CAUTION: Insert a clip clamp remover into the part shown by the arrow (between the clips and the body side panel). Remove door
finisher.
7. Disconnect harness connector for step lamp.
8. Pull up door finisher and pull out toward vehicle inside, and then disconnect inside handle cable and lock knob cable from back door finisher.
9. Disconnect harness connector for power window switch, seat memory switch.
10. Remove door finisher.
11. Remove the following parts after removing door finisher.
-
Inside handle assembly
-
Armrest