M35x AWD V6-3.5L (VQ35DE) (2007)
Traction Control Module: Service and Repair
ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
Removal and Installation
Exploded View BRC-56
CAUTION:
Be careful of the following.
^
Before servicing, disconnect the battery cable from negative terminal.
^
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use flare nut torque
wrench.
^
Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
^
Do not remove and install actuator by holding harness.
^
After work is completed, bleed air from brake tube.
^
After installing harness connector in the ABS actuator and electric unit (control unit), make sure connector is securely locked.
REMOVAL
1. Remove cowl top cover.
2. Disconnect ABS actuator and electric unit (control unit) connector.
3. Loosen brake tube flare nuts, then remove brake tubes from ABS actuator and electric unit (control unit).
4. Remove tire.
5. Remove fender protector (rear): (front LH side).
6. Remove ABS actuator and electric unit (control unit) bracket mounting nut.
7. Remove ABS actuator and electric unit (control unit) from vehicle.
INSTALLATION
Installation is the reverse order of removal.
CAUTION: When replacing ABS actuator and electric unit (control unit), make sure to adjust neutral position of steering angle sensor.