M35x AWD V6-3.5L (VQ35DE) (2007)
CAUTION:
If the adjustment screen does not appear on the CONSULT-II screen in 10 seconds. After touching "LASER BEAM ADJUST" screen,
the following causes may be considered:
-
Target is not set accurately.
-
There is not enough space beside the target.
-
The range of laser beam aiming exceeds for improper installation position.
-
Deformation of vehicle body.
-
Deformation of unit.
-
Deformation of bracket.
-
The area is not suitable for the adjustment work.
-
ICC sensor integrated unit is not clean.
5. After the CONSULT-II displays "ADJUST THE VERTICAL OF LASER BEAM AIMING" turn the up-down direction adjusting screw until
"U/D CORRECT" value is set in the range of ±4.
CAUTION: Turn the screw slowly. The value change on display is slower than actual movement of the ICC sensor integrated unit. Wait
for 2 seconds every time the screw is turned half a rotation.
NOTE: Turning the screw clockwise to laser beam is downward and counterclockwise to laser beam is upward.
6. When "U/D CORRECT" value indicates ±4, confirm that the margin of value remains within ±4 at least for 2 seconds with no equipment or hand
touching the ICC sensor integrated unit. When "COMPLETED THE VERTICAL AIMING OF LASER BEAM" appears on screen, touch "END".
CAUTION: Be sure that the margin of "U/D CORRECT" is within ±4 with ICC sensor integrated unit is untouched.