M35x AWD V6-3.5L (VQ35DE) (2007)
8. Loosen mounting bolts with power tool in reverse order as shown in the figure.
9. Remove rocker cover gaskets from rocker covers.
10. Use a scraper to remove all trances of liquid gasket from cylinder head and camshaft bracket (No. 1).
CAUTION: Do not scratch or damage the mating surface when cleaning off old liquid gasket.
INSTALLATION
1. Apply liquid gasket with the tube presser [SST: WS39930000 ( - )] to joint part among rocker cover, cylinder head and camshaft bracket (No. 1)
as follows:
Use Genuine RTV Silicone Sealant or equivalent. Refer to GI-47, "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS". See:
Service and Repair
NOTE: The figure shows an example of left bank side [zoomed in shows camshaft bracket (No. 1)].
a. Refer to the figure "a" to apply liquid gasket to joint part of camshaft bracket (No. 1) and cylinder head.
b. Refer to the figure "b" to apply liquid gasket to the figure "a" squarely.
2. Install new rocker cover gasket to rocker cover.
3. Install rocker cover.
^
Check if rocker cover gasket is not dropped from installation groove of rocker cover.