M35x AWD V6-3.5L (VQ35DE) (2007)
/Page-630003.png)
^
Loosen mounting bolts in reverse order as shown in the figure.
^
Use the seal cutter [SST: KV10111100 (J37228)] to cut liquid gasket for removal.
CAUTION: Shaft is internally jointed with camshaft sprocket (INT) center hole. When removing, keep it horizontal until it is completely
disconnected.
21. Remove collared O-ring from front timing chain case (left and right side).
22. Remove rocker covers (right and left bank).
23. Remove oil pans (lower and upper).
24. Obtain No. 1 cylinder at TDC of its compression stroke as follows:
a. Rotate crankshaft pulley clockwise to align timing mark (grooved line without color) with timing indicator.
b. Make sure that intake and exhaust cam noses on No. 1 cylinder (engine front side of right bank) are located as shown in the figure.
^
If not, turn crankshaft one revolution (360°) and align as shown in the figure.
25. Remove crankshaft pulley as follows:
