M35x AWD V6-3.5L (VQ35DE) (2007)
/Page-630017.png)
^
Install it so that each seal lip is oriented as shown in the figure.
^
Using a suitable drift [outer diameter: 60 mm (2.36 in)], press-fit oil seal until it becomes flush with front timing chain case end face.
^
Make sure the garter spring is in position and seal lip is not inverted.
13. Install water pump cover and chain tensioner cover to front timing chain case.
^
Apply a continuous bead of liquid gasket with the tube presser [SST: WS39930000 ( - )] to front timing chain case as shown in the figure.
Use Genuine RTV Silicone Sealant or equivalent. Refer to GI-47, "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS". See:
Service and Repair
14. Install front timing chain case as follows:
