M35x AWD V6-3.5L (VQ35DE) (2007)
Accelerator Pedal Position Sensor: Removal and Replacement
ACCELERATOR CONTROL SYSTEM
Exploded View ACC-3
Components
Removal and Installation
REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Remove front kicking plate and dash side finisher. Refer to "BODY SIDE TRIM".
3. Remove the cap and the inside mounting nut, and then disassemble the accelerator pedal pad from the floor carpet.
4. Press the pin (1) with long-nose pliers and pull them out in the direction shown by the arrow (<=). Then remove the accelerator pedal pad (2).