M35x AWD V6-3.5L (VQ35DE) (2007)
2.
Press [SUB MODE] (see Figure C) then:
a.
From the listed items, find and select [BATTERY CHARGE].
3.
Check the CONSULT-II's "Charger Input" reading (see Figure D).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts.)
CAUTION:
If the "Charger Input" is below 12 volts:
^
A list of items to check when "Charger Input" voltage is below 12V is contained in the "TCM Reprogramming For Infiniti Vehicles"
general procedure.
Step Three: Reprogram the TCM
Step Four: TCM Reprogramming "Wrap-up"
1.
Turn the ignition and CONSULT-II OFF.
2.
Disconnect CONSULT-II from the vehicle.
3.
Start the Engine and make sure the MIL is OFF.
^
If the MIL is ON, use CONSULT-II with the Diagnostic (red/white) Card to erase any DTC's that may have stored in the TCM and/or the
ECM during the reprogramming procedure.
4.
Test-drive the vehicle and make sure the transmission operates correctly in all modes.
^
See the AT section of the appropriate Service Manual for operation specification.