M35x AWD V6-3.5L (VQ35DE) (2007)
Power Distribution Module: Reading and Clearing Diagnostic Trouble Codes
CONSULT-II Function (IPDM E/R)
CONSULT-II BASIC OPERATION
Refer to GI-38, "CONSULT-II Start Procedure". See: Testing and Inspection
Self Diagnostic Result
SELF-DIAG RESULTS
Operation Procedure
1. Touch "SELF-DIAG RESULTS" on "SELECT DIAG MODE" screen.
2. Check display content in self-diagnostic results.
Display Item List - Self-Diag Results
Display Item List
Auto Active Test
Auto Active Test
DESCRIPTION
In auto active test mode, operation inspection can be performed when IPDM E/R sends a drive signal to the following systems:
-
Rear window defogger
-
Front wiper (LO, HI)
-
Tail lamps, parking lamps and license plate lamps
-
Front fog lamps
-
Headlamps (LO, HI)
-
A/C compressor (magnetic clutch)
-
Cooling fan
-
Oil pressure warning lamp
OPERATION PROCEDURE
1. Close hood and front door (passenger side), and then lift wiper arms away from windshield (to prevent glass damage by wiper operation).
NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand.
2. Turn ignition switch OFF.
3. Turn ignition switch ON, and within 20 seconds, press driver's door switch 10 times (close other doors). Then turn ignition switch OFF.
4. Turn ignition switch ON within 10 seconds after ignition switch OFF.
5. When auto active test mode is actuated, horn chirps once. Oil pressure warning lamp starts blinking.
6. After a series of operations is repeated three times, auto active test is completed.
NOTE: When auto active test mode has to be cancelled half way, turn ignition switch OFF.