infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Technician Safety Information|Page 2085 > < Technician Safety Information|Page 2083
Page 2
background image

WARNING:
-

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would
result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.

-

Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional
activation of the system. For removal of Spiral Cable and Air Bag Module, see the "SUPPLEMENTAL RESTRAINT SYSTEM".

-

Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses
can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:
-

When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition ON or engine running, DO
NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy
the air bag(s), possibly causing serious injury.

-

When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the battery, and wait at least 3 minutes
before performing any service.

Precautions For Trouble Diagnosis

PRECAUTIONS

Precautions for Trouble Diagnosis

CAUTION:
-

Never apply 7.0 V or more to the measurement terminal.

-

Use a tester with open terminal voltage of 7.0 V or less.

-

Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness.

Precautions For Harness Repair

PRECAUTIONS

Precautions for Harness Repair

-

Solder the repaired area and wrap tape around the soldered area.

NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).

-

Bypass connection is never allowed at the repaired area.

NOTE:
Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

Technician Safety Information|Page 2085 > < Technician Safety Information|Page 2083