M35x AWD V6-3.5L (VQ35HR) (2010)
Seals and Gaskets: Service and Repair
Rear Oil Seal
REAR OIL SEAL
Removal and Installation
REMOVAL
1. Remove the rear propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Testing and Inspection/Component Tests
and General Diagnostics/Rear Propeller Shaft.
2. Remove self-lock nut of companion flange using a flange wrench.
3. Put matching mark on the end of the mainshaft. The mark should be in line with the mark on the companion flange.
CAUTION:
For matching mark, use paint. Do not damage mainshaft.
NOTE:
The figure shows VQ35HR models.
4. Remove companion flange using pullers.
CAUTION:
Be careful not to damage the companion flange.
-
VQ35HR models