M37 V6-3.7L (VQ37VHR) (2011)
14. When the screen in Figure 43 appears click on All Erase.
15. Click on Yes (see Figure 43).
16. Use the scroll bar to scroll down the page and make sure all DTCs are erased (see Figure 43).
^ For any DTCs that do not erase: diagnose perform repairs and erase DTCs.
^ Refer to the ESM as needed.
^ Diagnosis and repair for DTCs is not covered by this campaign.
17. Close C-III and then turn the ignition OFF.
18. Turn the ignition ON but do not start the engine.
^ Make sure the 4WAS light goes out in less than two (2) seconds. See Figure 44.