M37 V6-3.7L (VQ37VHR) (2011)
4. Compare the P/N you wrote down to the numbers in the Current TCM P/N column in Table A above.
^ If there is a match, this bulletin applies. Continue with the reprogramming procedure.
^ If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
5. If this bulletin applies and you have performed TCM reprogramming; when reprogramming is complete, the screen in Figure 2 displays.
6. Erase DTCs in all systems.
^ During TCM reprogramming, DTCs will set in several systems and must be erased before ECM reprogramming.
7. Go to ECM Reprogramming below.
ECM Reprogramming
^ Make sure to erase DTCs from all Systems.
^ If you are not familiar with the reprogramming procedure, refer to "CONSULT- III (C-III) ECM Reprogramming" general procedure.
1. Restart the C-III session by selecting the Home icon in the upper left corner of the screen.