M45 V8-4.5L (VK45DE) (2006)
^
If the I-Key has a dead battery the engine can still be started by inserting the I-Key into the In-Dash Key Port located to the left of the steering
column (see Figure 1).
^
The mechanical emergency key can be used to open the doors and trunk.
^
For information on how to register the Intelligent Key NATS Key and Steering Lock Unit please refer to ITB05-007.
Window Operation and Initialization
If the windows will not operate in the Auto-Mode and any of the following conditions have occurred the windows should be initialized.
^
Battery cable is disconnected
^
Power window switch connector is disconnected
^
Power window regulator is replaced
^
Power window motor is replaced
^
Window glass is removed
^
Window glass run rubber is replaced
^
Power window fuse is blown
Window Initialization Procedure
1.
Turn the Ignition switch "ON".
2.
Open the window more than halfway using manual-switch (NOT Auto-Mode) operation.
NOTE:
If the window is already open more than halfway go to step 3.
3.
Close the window using the manual-switch operation and hold the switch UP for 3 to 4 seconds after the glass reaches the fully closed position.
4.
Confirm the window you are working on is operating properly.
5.
Then confirm all other windows are operating properly.