M45 V8-4.5L (VK45DE) (2006)
a.
Remove both cable covers; reach under to release the clips.
b.
Remove 2 bolts.
c.
Lift the motor and pull out the cable ends.
d.
Install the slide motor in the new seat adjuster assembly in reverse order.
^
Use new cable covers.
^
Use new bolts.
^
Bolt torque: 9.5 N.m (1.0 Kg-m, 7.0 ft.lb)
NOTE:
There is no need to set a specific position of the motor or the slides. The slides were set to equal distance at the factory.
Service Procedure - Part 2
41.
Remove the rear lifter motor; 3 nuts. Set the motor aside for now.