M45 V8-4.5L (VK45DE) (2006)
/Page-1344001.png)
Brake Master Cylinder: Service and Repair
Disassembly and Assembly
Disassembly and Assembly
DISASSEMBLY
CAUTION:
^
Master cylinder cannot be disassembled.
^
Remove reservoir tank only when absolutely necessary.
^
When securing master cylinder assembly in a vise, be sure not to over-tighten.
^
When securing in a vise use copper plates or cloth to protect the flange.
1. Using a pin punch [commercial service tool: diameter approximately 4 mm (0.16 inch)], remove mounting pin on reservoir tank.
2. Remove reservoir tank and grommet from cylinder body
ASSEMBLY
CAUTION:
^
Never use mineral oils such as kerosene, gasoline during the cleaning and assembly process.
^
Do not drop parts. If a part is dropped, do not use it.
1. Apply brake fluid to the grommet and attach it to the cylinder body.
CAUTION: Do not reuse grommet.
2. Install reservoir tank onto the cylinder body.
3. Secure master cylinder assembly into a vise with a chamfered pin insert hole on cylinder body facing upward.
4. Tilt reservoir tank as shown in the figure and insert mounting pin.
Return reservoir tank to a upright position when mounting pin passes through the pinhole in the cylinder body. Push the mounting pin to the
opposite pinhole of the reservoir tank so that it is the same conditions as the insertion side.
CAUTION:
