M45 V8-4.5L (VK45DE) (2006)
c.
Wait until the data transfer is complete (see the CAUTION above).
^
When the data transfer is complete CONSULT-II will turn OFF automatically.
d.
Disconnect the A/C power cord and the Ethernet cable from CONSULT-II.
Part 4: Reprogram the ICC control unit with the 8 MB (orange) reprogramming card
CAUTION:
^
Perform this operation in 6 sections. DO NOT SKIP any of these sections as shown below.
^
The sections must be performed in order, 1 through 6. (Refer to the "Sections Procedure").
Section 1 - 6
The sections must be performed in order 1 through 6.
Section 1:
Connect ICC reprogramming cable to the ICC control unit.
Section 2:
Connect a battery charger and CONSULT-II to the vehicle.
Section 3:
Check / adjust the vehicle battery voltage / CONSULT-II "Charger Input voltage.
Section 4:
Check CONSULT-II Converter version.
Section 5:
Perform ICC Control Unit Reprogramming.
Section 6:
Perform "erase" procedure for all systems in SELF-DIAG RESULTS.
Section 1: Connect ICC reprogramming cable to the vehicle.
1.
Remove the front grille.
a.
Open the hood.
b.
Remove the 4 upper clips shown in Figure 11.